TechPaladin Printing

Leadscrews and couplers

I’ve been selling budget-priced leadscrews and nuts for a bit now, but now I finally have 5mm-to-6.35mm motor couplers to go along with them. These leadscrews and couplers are a natural match if you’re looking to tighten up your layer alignment and increase the speed of your Z-axis layer transitions. Just make sure that your X-ends’ printed nut traps tightly hold the nuts!

leadscrews_nuts_and_couplers.jpg

Categorised as: 3D printing, Hardware, Store


5 Comments

  1. Anthony Morris says:

    A friend recently ordered these and they work great with the aleph objects X ends. Great thing about those particular X ends is you can choose exactly what you want to use as far as linear motion too. Bushings, LM8UUs, PLA bearings, etc are all changable.

  2. David LeBer says:

    I’m looking to upgrade my printer with these along with the couplers and GT2 pulleys and belts.

    Is there anyway of being notified when this stuff is restocked?

    D

    • Nathaniel says:

      My store software doesn’t have any kind of automated way for you to do that, but I’d be happy to email you when I’ve got ‘em in again!

  3. Basilis Neururer says:

    Hey I’d really like to get a pair of couplers + leadscrews (+nuts), any idea when they’ll be available again?

  4. Nathaniel says:

    Hi Chris,
    I’m terribly sorry for this problem, and I apologize for the late reply! I’ll be sending out replacement leadscrews tomorrow morning.